Publicidad
8.
9.
Turn fuel valve to the ON position,
1/4 turn counterclockwise.
Move the choke control lever to
the CHOKE ON N position and
the throttle control to the FAST
position. NOTE: No choke is
needed to start a warm engine.
10. Pull starfer grip slowly until you
feel resistance, then pull briskly.
Return starter grip gently. Pull
rope with a rapid full arm stroke.
Let rope rewind slowly. Repeat if
necessary.
If the engine does
not start after two
pulls, pull the trigger to relieve the
pressure.
11. If the choke was used to start the
engine, move the choke lever to
the OFF position.
12. Depress trigger on gun to start
water flow. NOTE: Stand on a
stable surface
and grip
gun/spray wand firmly with both
hands. Expect the gun to kick
back when triggered.
13. Release trigger to stop water flow.
14. Adjust nozzle spray for the task
being performed. See How To
Use Spray Wand instructions in
this section.
DO NOT let hoses
come in contact with
very hot engine muffler
during or
immediately
after use of your
pressure washer.
When performing maintenance,
you may be exposed to hot
surfaces, water pressure, or moving parts that can cause
serious injury or death!
Before performing
any maintenance
or repair, disconnect
spark plug wire,
let engine cool and release all water pressure. The engine contains
flammable fuel. DO NOT smoke or work near open flames while performing
maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed.
If the pressure washer is
used in unusual conditions,
such as high-temperatures
or dusty conditions,
more
frequent maintenance checks will be required.
13- ENG
D28234
Publicidad
