Publicidad
Idiomas disponibles
Idiomas disponibles
5. Squeeze lower handle in; position holes
onto mounting pins on handle bracket.
6. Reassemble
upper handle and all
parts removed from lower handle.
Mowing
_.
Mowing
position
_ _
D,.
position
[_'?
I
I
iI
I
f
I
i
I
I
I
i
i
I
i
I
I
i
I
I
iI
I
l
A
I
;
._
cotter---'_)
r_HarLdl e _,_
_
I_
M.ont_racke_
pin
_
_"
_
-a"
LOW POSITION
HIGH POSITION
ENGINE
Maintenance,
repair, or replacement
of
the emission control devices and systems,
which are being done at the customers
ex-
pense, may be performed by any non-road
engine repair establishment
or individual.
Warranty repairs must be performed by an
authorized engine manufacturer's
service
outlet.
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair & adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
Immediately
prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a pe-
riod of time, clean it thoroughly, remove all
dirt, grease, leaves, etc. Store in a clean,
dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance sec-
tion of this manual).
2. Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws,
and pins are securely fastened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
HANDLE
You can fold your mower handle for storage.
NOTE: The upper handle has an "anti-fold"
bracket located on the right side of the
handle. This bracket prevents the upper
15
handle from folding forward, which helps
protect control cable(s) from damage.
1. Squeeze the bottom ends of the lower
handle toward each other until the
lower handle clears the handle bracket,
then move handle forward.
2. Loosen upper handle mounting bolts
enough to allow upper handle to be
folded back.
IMPORTANT;
When folding the handle for
storage or transportation, be sure to fold
the handle as shown or you may damage
the control cables.
• When setting up your handle from the
storage position, the lower handle will au-
tomatically lock into the mowing position.
SQUEEZE
TO FOLD
Publicidad
