Publicidad
Idiomas disponibles
Idiomas disponibles
SP6593
Sears
Kenmore
7/21/@5
2:16
PH
_ge
4
How Your Humidifier
Works
Your new Kenmore humidifier is designed
to satisfy home humidity requirements
through the principle of evaporation of
water in the air.
After water is added to the bottle, the
filters begin to soak up the water and
become totally saturated in approxi-
mately 30 minutes. Air is drawn in from
the rear of the humidifier and through the
filters by means of circulation fans. As air
passes through the filters, moisture is
absorbed into the air and then released
in the form of vapor. No water droplets
will enter the home. AII evaporation into
the air takes place in the humidifier,
which means that the residue left by
evaporating water is not passed into the
home, but remains in the filter.
CAUTION:
Use only 32-14900 EPA
Registered Bacteriostat available
from Sears Retail store. Under no
circumstances
should you use water
treatment products designed for
Rots belt or Ultrasonic humidifiers.
Humidified
Air is Then
Remeased Through
the Top
Dry Air
Enters
Through
the Rear
CAUTION:
To reduce the risk of
injury, fire or damage to humidifier,
use only cleaners specifically
recommended
for humidifiers. Never
use flammabie, combustible or
poisonous materials to clean your
humidifier.
To reduce the risk of scalds and
damage to humidifier, never put hot
water in humidifier.
Assembly
Your new Sears Kenmore humidifier is
completely assembled for you to use.
Remove the bag pack containing two
plastic caster pads from top of humidifier
and retain for future use if required. See
the following Step 1 for instructions.
Remove the packaging material from
inside your humidifier and follow the
instructions of this operator's manual for
proper usage. The packaging material is
located under the fan assembly. Remove
the packaging material and discard.
Publicidad
