10
Ultraviolet Bulb Repla(ement
The Halo
TM
UV-ST Ultraviolet Vacuum was designed so that bulb replacement is not
necessary during normal operating life. As such, the bulb should only be replaced
by qualified service personnel. PLEASEDO NOT ATTEMPT TO CHANGE THE BULB
YOURSELF. S hould there be any problem with the bulb, please visit gethalo.com or
call 1-866-638-HALO (4256) for more information. Please keep in mind that, like all
fluorescent lamps, the ultraviolet lamp used inside your Halo
TM
Ultraviolet Vacuum
contains a small amount of mercury. Please manage and make any disposal of your
Halo
TM
ultraviolet bulb in accordance with local disposal laws. For more information,
please see www.lamprecycle.org or call 1-866-638-HALO (4256).
Reset Button
The Halo
TM
Ultraviolet Vacuum has a feature that protects the product when
something gets caught in the brush bar and the motor that turns the brush bar
overheats. If the brush bar stops turning, please first make sure that the product
gets turned OFF and ON. Then if the brush bar is still not turning, please turn the
product OFF again, inspect the brush bar to ensure it is free of all hair, threads,
strings, etc. that could prevent the brush bar from turning freely and then press
the "Reset" button on the back right corner of the product.
If the product still does not turn ON, then please contact Halo
TM
Customer Service
at !-866-638-HALO (4256) or gethalo.com.
Overheotin 9 Cutoff
The Halo
TM
Ultraviolet Vacuum has a switch inside the product that protects the
motor from overheating. If you find that the product suddenly turns off, then
please immediately unplug the product. Make sure that the dust filter bag is not
full, and then do not turn the product ON for a few minutes. After a brief wait
period, feel free to plug the product into an appropriate electric outlet and turn the
product ON.
If the product still does not turn ON, then please contact Halo
TM
Customer Service
at !-866-638-HALO (4256) or gethalo.com.