Aqara E1 Manual De Usuario página 25

Incorrect installation
of the thermostat
The temperature is set too high
LCD screen
displays a
Valve fault
fault icon
6
The room is too large
(the radiator does not
match it) or over-ventilated
Low water inlet pressure
or temperature
Note: In case of any issue not resolved, please contact the after-sales department -
support@aqara.com
Remove the thermostat from the valve,
take out the batteries and put them back
after 30 seconds, reinstall the thermostat
and observe whether the fault persists.
Replace the batteries.
Replace the valve, take out the batteries
and put them back after 30 seconds, and
then reinstall the thermostat.
Replace the radiator or check
whether the doors or windows are
open or not fastened.
Check the water inlet pressure and
temperature.
-22-