Technical Data; Safety Instructions; Mains Connection - AEG PT 560 Instrucciones De Uso

TECHNICAL DATA

Nominal power output ...........................................................
Air temperature
Level 1 ................................................................................
Level 2 ................................................................................
Air volume
Level 1 ................................................................................
Level 2 ................................................................................
Weight without cable .............................................................

SAFETY INSTRUCTIONS

Please pay attention to the safety instructions in the attached
leaflet!
Danger of fire if not used properly!
Take care if using the device in the vicinity of combustible
materials. Do not direct the device towards the same place for
long periods.
Do not use the device outside if it is raining.
Do not touch the hot air nozzle during operation (danger of
burning!).
Never cover or close the hot air nozzle.
Do not point the hot air flow at people.
Do not leave the device unattended while switched on.
Allow the device to cool down for a while after use before
packing it away.
Do not use the device as a hair dryer.
Do not use the device in rooms with a potentially explosive
atmosphere.
Do not use the machine in areas where there are possibly
highly inflammable materials or gasses
Heat accidentally could be directed towards concealed
combustible materials.
Always disconnect the plug from the socket before carrying
out any work on the machine.
Only plug-in when machine is switched off.
Before use check machine, cable, and plug for any damages
or material fatigue. Repairs should only be carried out by
authorised Service Agents.
Keep mains lead clear from working range of the machine.
Always lead the cable away behind you.
Always disconnect the plug from the socket after use.
SPECIFIED CONDITIONS OF USE
The device is not suitable for soldering copper pipes,
galvanizing bodywork parts, welding plastics, thawing out
water pipes or heating metal parts.
Do not use this product in any other way as stated for normal
use.
5 ENGLISH
PT 560
........................1500 W ......................................2000 W
..........................300 °C ................................. 90-600 °C
..........................560 °C ................................. 90-600 °C
..........................400 l/min ....................................300 l/min
..........................450 l/min ....................................500 l/min
..........................600 g .........................................600 g
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized
documents. EN 60335, EN 55014-1, EN 55014-2, EN 61000-
3-2, EN 61000-3-3, in accordance with the regulations 73/23/
EEC, 89/336/EEC

MAINS CONNECTION

Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also possible
to connect to sockets without an earthing contact as the
design conforms to safety class II.
MAINTENANCE
The ventilation slots of the machine must be kept clear at all
times.
Use only AEG accessories and spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service agents (see
our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the Article No. as well as the machine type
printed on the label and order the drawing at your local
service agents or directly at: AEG Elektrowerkzeuge,
Max-Eyth-Straße 10, D-71364 Winnenden, Germany.
SYMBOLS
Always disconnect the plug from the socket
before carrying out any work on the machine.
Accessory - Not included in standard equipment,
available as an accessory.
PT 600 EC
Volker Siegle
Manager Product Development