Sthor 78113 Manual Original página 10

PRODUCT CHARACTERISTICS
The impact driver is a versatile portable tool that does not require an external power source designed for DIY enthusiasts only for
screwing and unscrewing screws and nuts with left-hand and right-hand thread using a variety of screwdriver bits. Thanks to its
impact mechanism, the driver provides signifi cantly higher torque than a typical cordless drill driver. Its specifi c advantages will be
appreciated by DIY enthusiasts performing various assembly and fi nishing works. Proper, reliable and safe operation of the power
tool depends on appropriate use, that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
EQUIPMENT
The product is delivered complete, but requires certain preliminary assembly actions described in further sections of the manual.
The product is supplied without a battery and charging station.
TECHNICAL DATA
Parameter
Catalogue No.
Operating voltage
Revolutions (idle speed)
Impact frequency
Max. torque
Noise level
- sound pressure
- power L
WA
Protection rating
Insulation class
Vibration level
Weight
Tool chuck
Battery type
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
O R I G I N A L
10
EN
Unit
[V]
[min ]
-1
[min -1 ]
[Nm]
[dB]
[dB]
[m/s 2 ]
[kg]
[mm / "]
I N S T R U C T I O N S
Value
78113
20 DC
0 – 2500
0 – 3500
150
75.8 ± 3.0
86.8 ± 3.0
IPX0
III
0.414 ± 1.5
1.2
6.3 / 1/4
Li-Ion