Publicidad
Idiomas disponibles
Idiomas disponibles
4.After adjusting
the doors, insert the supplied
fastener (6)using a pliers (5)inthe gap
between
the hinge-grommet
(7)and the lower
hinge (8).
The number
offasteners
you'll need t oinsert
depends
onthe gap.
2fastener
are enclosed
with the
refrigerator.
The t hickness
ofeach f astener
is0.04".
z_ WARNING
Children should be supervised to ensure that
they do not play with the fastener.
There is a risk of death from suffocation if a
child swallows the fastener.
Pay special attention to children because it can
be dangerous.
Keep the fastener out of reach of children.
INSTALLING
THE WATER
DISPENSER
LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize the water or destroy
microorganisms.
You may need to purchase a
water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 - 125 psi (138 - 862 kPa) is
required.
if the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
®
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and a 1A" compression nut.
Connecting
to the water
supply
line
1. First, shut off the main water
supply.
2. Locate the nearest cold water drinking line and
install the pipe clamp and shut off valve.
Shut off valve
3. Connect the water line installation kit to the
shut off valve.
Water line installation kit
iiiiiiiiiiiiiiii
Engl sh --15
Publicidad
