Publicidad
Tools Required: Rubber Mallet or Padded Hammer, Outdoor Wood Glue, Phillips Screwdriver
1.
Remove the Granite Top (M), Wooden Lid (L), Plastic Tub (ZG) and Drawers (N).
P
NOTE: When applicable, use a variable speed drill with the provided Straight Hex Wrench (ZH)
throughout this assembly instead of the provided Bent Hex Wrench (T). Doing so will make this
assembly easier.
2.
Turn the Top Assembly (A) upside down on a clean, protected surface. Lay the Drop Leaf (S) flat.
Spread a thin layer of outdoor wood glue in the dowel holes at the tops of the Right and Left Back
Legs (B and D) and position them over the dowels of the Top Assembly (A). Gently tap with a
rubber mallet and quickly wipe away excess glue. Using the predrilled holes as guides and the
provided hex wrench (ZH or T) of your choice, affix the Right and Left Back Legs (B and D) with
four 6x40mm Hex Screws (P). See Figure 2.
4303KFBA Serving Cart
Assembly Instructions
Tools Provided: Bent Hex Wrench ; Straight Hex Wrench
Optional Tools: Variable Speed Drill, Phillips Driver Bit
D
Fig. 2
B
A
P
x 4
S
4303KFBA_Page 3_12/09
Publicidad
