Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING
13. Remove and reinsert each Spirit Bottle, and replace the Water Reservoir onto the
base.
14. Repeat steps 9 through 13 four additional times, for a total of 5 cleaning cycles.
15. Remove Spirit Bottles and Water Reservoir from unit and discard cleaning
solution.
16. Rinse Spirit Bottles, Water Reservoir, and Capsule
Holder with clean water.
17. Add 2 cups (473 mL) of clean water to each Spirit Bottle
and Water Reservoir.
18. Place Spirit Bottle Lid on each Spirit Bottle and screw
Lids securely in place.
19. Insert Spirit Bottles with clean water in all four Bottle Holders.
20. Insert Water Reservoir with clean water in position on the Base.
21. Reposition the Capsule Holder into place in the upper housing.
22. Place a 16 oz (455 mL), or larger, container under the Dispenser, on the Bar Mat.
23. Follow steps 9 through 13 to rinse cleaning solution from unit.
24. Repeat step 23 four additional times, for a total of 5 rinse cycles.
25. Remove Spirit Bottles and Water Reservoir from the unit and discard the clean
water.
26. Run "Transport" cycle, as described on page 10, to
remove water from unit.
27. Air dry Spirit Bottles and components and the unit is
ready for use.
Cleaning Removable Parts
1. To remove Capsule Holder, lift Lid Handle. Push
Capsule Holder from bottom center to pop out.
CAUTION: The Capsule Holder contains a sharp
needle that punctures the Cocktail Capsule. To avoid
risk of injury, do not put your fingers inside the
Capsule Holder.
a. To clean, press the 3 tabs on bottom of the
Capsule Holder to release the ring from Capsule
Holder Piercing Cup. Handle Springs carefully to
prevent them from becoming lost.
|
12
Bartesian Customer Care 1.833.501.6889
Transport
Publicidad
