Publicidad
Idiomas disponibles
Idiomas disponibles
GETTING STARTED
Important Instructions Before First Use
Remove Cocktail Machine and components from box and place on a flat, sturdy
surface. Wash all removable parts following "Care and Cleaning" instructions. Since
the mixers in the Cocktail Capsules are concentrated, all drinks are mixed with water
to deliver the optimal flavor. Before using the Cocktail Machine, the water line needs to
be primed. Follow these instructions in order to prime the system for first use.
1. Remove the Water Reservoir from the Base and fill with water only. Do not fill with
mixes, juices, club soda or other liquid. Cocktail Machine will stop working and
void warranty if other liquids are used.
NOTE: Because water quality varies, use bottled or filtered water for the best-
tasting premium cocktails.
2. Place Water Reservoir in Base.
3. To fill the Spirit Bottles, first you must open the Bottle
Lock Lever to remove the bottles. To unlock Bottle Lock,
follow these steps.
a. Insert key and rotate counterclockwise until it stops.
b. On left side, place fingers under recessed area and
pull Lock Lever out.
c. Bottles are now unlocked.
d. To remove, slightly tip Spirit Bottle and slowly pull up.
4. Fill each Spirit Bottle with spirits as indicated on Spirit
Bottle Lids. Place the lid inside the collar and screw Lids
securely in place.
5. Tip Spirit Bottles upside down and insert into Spirit
Bottle Holders on Base. Spirit Bottles will snap into
place.
NOTE: Gin and Rum share the same Holder. The
Cocktail Machine will prompt you to switch bottles if necessary for your cocktail. It
is very important to put the Spirit Bottles in the correct Spirit Bottle Holder. If in the
wrong position, the finished cocktail will be incorrectly mixed.
6. Once the bottles are fully seated into position, push the Bottle Lock Lever into the
closed position and engage the Lock (turn clockwise).
7. Insert Removable Power Cord end into Power Cord Port in back of Base.
8. Plug into outlet. Press the Control Panel, rotate Selector Dial, or open and close the
Lid Handle to wake up the Cocktail Machine. Home screen will be displayed.
9. Center an 8-ounce (237 mL) container under Dispenser.
10. To get to the Menu for the First Use, hold button down while rotating Selector Dial.
Release button when the First Use ( ) screen is displayed, then press the Control
Panel and follow prompts to prime water line.
NOTE: All four Spirit Bottles do not need to be filled and installed for Cocktail
Machine to operate, only Spirit Bottle(s) listed on label of Cocktail Capsule in use.
|
bartesian.com
7
Publicidad
