Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (152 cm) of clearance on all sides of
pressure washer including overhead.
• Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
How to Stop Your Pressure Washer
1.
Release spray gun trigger and let engine idle for two
minutes.
2.
Move throttle to SLOW position, then STOP position.
WARNING
Backfire, fire or engine damage could occur.
• DO NOT stop engine by moving choke lever to "Choke" position.
3.
ALWAYS point spray gun in a safe direction, press red
button and squeeze spray gun trigger to release retained
high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button
and squeeze spray gun trigger, to release high pressure, every
time you stop engine.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your Quick Connect spray tips, spray gun and spray tip
extension. There is also a hook at the front of the accessory
tray to hold your high pressure hose. Identify all accessories
with the illustration on page 6.
NOTE: The extra hole in the tray is for storing a utility brush.
The extra clip in the tray is for storing a turbo spray tip. The
brush and turbo spray tip are NOT included with your
pressure washer. You can buy these items as optional
accessories.
1.
Place spray tip extension through hole on accessory
tray, as shown.
2.
Place spray gun through hole on accessory tray on right
side of unit.
3.
Insert multi–colored Quick Connect spray tips in spaces
provided in accessory tray.
4.
Hang high pressure hose on hook attached to accessory
tray on front of tray as shown.
How to Use Spray Tips
The quick–connect on the spray tip extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown on next page.
Follow these instructions to change spray tips:
1.
Pull back collar on quick–connect and pull current spray
tip off. Store spray tips in holder provided on accessory
tray.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange Quick Connect spray tips without the trigger
locked on the spray gun.
• DO NOT twist Quick Connect spray tips while spraying.
13
WARNING
Publicidad
