Descargar Imprimir esta página

Craftsman 580.752290 Manual Del Operador página 15

Ocultar thumbs Ver también para 580.752290:

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning and Applying Detergent with
the Standard Clear Siphon
To apply diluted detergent using the
standard clear siphon tube,
follow these steps:
1.
Review use of black spray tip.
2.
Attach clear siphon hose to pump.
3.
Mix detergent solution as required by job.
4.
Place small filter end of clear siphoning tube into
container with diluted solution as described above.
NOTICE
Contact with the hot muffler can damage detergent
siphoning tube.
• When inserting the siphon into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting the
hot muffler.
NOTE: Make sure the filter is fully submerged in fluid while
applying solution.
5.
Make sure black spray tip is installed.
NOTE: Detergent cannot be applied with the high pressure
spray tips (Yellow, White or Red).
6.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray gun
and pump. Turn on water.
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
7.
Start engine following instructions How to Start Your
Pressure Washer.
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
For best results, scrub the detergent covered surface to help
remove stubborn dirt, grime and stains. For vehicles, use a
soft car wash brush or mitt. For decking, siding and
concrete, use a brush appropriate for the type of surface
being cleaned.
IMPORTANT: You must flush the detergent siphoning system
after each use by placing the filter into a bucket of clean
water, then run the pressure washer in low pressure for 1-2
minutes.
15
NOTICE

Publicidad

loading