MSW Motor Technics S-SPOTTER 3500 Manual De Instrucciones página 9

Idiomas disponibles

Weld 2 washers on a metal work surface as close as possible.

Connect the washers with a wire.

Apply a metal lock to the washers.

Insert locking bolt.

Tighten the lock.

4.4 DEVICE OPERATION

4.4.1 WELDING WASHERS

Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect the adapter

for washers to the gun, then insert a washer. Set the required welding current.

Set the welding time. Align the gun with the surface at a 90°C angle, then apply pressure to the gun and

press the trigger. Remove the gun. Use the hammer to remove a welded washer: insert the hammer hook

through the washer eye and move the hammer handle quickly towards you.

4.4.2 WELDING TRIANGULAR WASHERS

Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect the adapter

for triangular washers to the gun, then insert a washer. Set the required welding current.

Set the welding time. Align the gun with the surface at a 90°C angle, then apply pressure to the gun and press

the trigger. Remove the gun. Use the hammer to remove a welded washer: insert the hammer hook through

the washer eye and move the hammer handle quickly towards you.

4.4.3 CARBON ROD HEATING UP

Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect the carbon

rod and the adapter to the gun. Set the required welding current.

Set the welding time. To heat up sheet metal, rotate the carbon rod clockwise. Use cold water or a wet cloth

to cool down the hot surface. This will cause the sheet metal to shrink back to its normal state.

4.4.4 WELDING ZIGZAG WIRE

Connect the earth cable to a clean, unpainted work surface, near to the welding spot. Connect an

appropriate electrode. Set the required welding current.

Set the welding time. Align the zigzag wire with the work surface, align the gun at a 90°C angle, then apply

pressure to the gun and press the trigger. Connect the hook with the hammer, quickly move the hammer

handle to "pull out" the dent.

ATTENTION! The device is protected against overheating, during operation the device may switch of and

activate its fans to cool down. Refrain from using the device for 15 minutes until it cools down. If this occurs

frequently reduce the welding current and / or the welding time.

ATTENTION! To prevent damaging the work surface, test the operation of the device on a different piece

of metal (with the same properties) to adjust the welding current and time.

Rev. 23.11.2018