Publicidad
Idiomas disponibles
Idiomas disponibles
m@ OPERATION
Recording
1 Power: "on" (= —> =)
2 Press and insert
the tape cassette.
3 Press.
7 Press.
(Recording stand-by mode)
8 Begin the program source
1 1 Press.
(Recording will begin.)
to be recorded.
To erase recorded
sounds
1. Set the Dolby noise-reduction switch to the "out" position.
2. Set the input level control to the minimum (0) position.
3. Prepare in the same way as for recording, and then let the
tape run.
Note that any sounds on the tape will be automatically erased
if a new recording is made on that part of the tape.
Timer Recording/Playback
The side to be recorded
facing outward.
Part where tape is exposed
facing downward.
eee Lencesoepotaednpeannserte
RS-B205
RS-B205
4 Select the noise-reduction system.
5 Select the sound source.
6 Set to position corres-
ponding to type of tape to
be used.
9 Adjust the recording level.
(Refer to below.)
1 0 Adjust left/right volume balance.
Adjustment of the recording level
The numbers which you should use as a guide for the adjust-
ment of the tape level will differ depending upon the type of
tape.
Normal tape
CrO, tape
Metal tape
If an audio timer (option) is connected to this unit, recording of a radio broadcast, or tape playback, will automatically begin at the
preset time.
Connect the AC power cord of this unit to the power source outlet of the timer.
Timer recording
1. Prepare for recording.
(Follow
steps
1
through
10
of
"Recording".
After
adjusting the recording level, press the stop button and the
pause button.)
Set the timer to the desired recording-start time.
Press the record button.
(At the set time, the power will switch ON and the broad-
cast will be recorded.)
bad
After setting the timer
Make sure that the power switch is set to the "on" position.
—3-—
Timer playback
1. Rewind
the tape to the position from which you want
playback to begin.
2. Set the timer to the desired playback-start time.
3. Press the playback button.
(At the set time, the power will be switched ON and the
playback will begin.)
After setting the timer
Make sure that the power switch is set to the "on" position.
m@ DISASSEMBLY INSTRUCTIONS
How to remove the mechanism
unit
Procedure
;
j e c t
butt
fig. 1).
55
1. Push the eject
button (see
fig.
1)
2. Remove the 4 screws (@~@).
3. Remove
the
counter
belt
(for
Case Cover
mechanism.
Counter
LS
Eject Button
:
7
<>
i
<2
Mechanism Unit
Fig. 2
sage i
How to remove the LED meter P.C.B.
saa
How to remove the volume P.C.B.
1. Remove the 2 screws (@, @).
2. Pull out the volume knob.
e Remove the 2 screws (@, ©).
eRemove the 4 tabs aside.
\
LED Meter P.C.B.
Procedure
Procedure
132-35
1. Remove the 2 screws (@, @).
455
2. Open the 2 tabs aside, and then
pull down the back chassis.
? Serial Number
a
- ry
* Serial No. Indication
© The serial number plate of the product is attached to the back chassis (shown in fig. 6).
—
4
—
Publicidad
