Control Panel; Light Switch - Whirlpool AKR 810 IX Manual De Uso

N.B.: We recommend placing the bracket at equal distances from the ceiling and the lower bracket welded to the truss.
20. Fit the cage nuts provided inside the top section of the flues.
21. Assemble the upper sections of the flue covering the truss.
22. Secure the two parts with the screws as shown.
23. Attach the upper section of the flue to the truss secured to the ceiling.
24. Fit the cage nuts provided inside the lower section of the flue, through the square slots.
N.B.: this section should preferably be installed on the lower side.
25. Assemble the lower sections of the flue covering the truss.
26. Secure the two parts using the screws as shown.
27. Fit the flues in their seat over the hood and completely covering it. .
28. Remove the grease filter/s.
29. Secure the lower sections of the flues from inside the hood, using the screws as shown.
30. For Filter Version only: Fit the carbon filter
N.B.: Some models may already have a carbon filter (installed and supplied with the appliance); if not, it must be ordered separately.
31. Fit the lower tabs (hook fitting).
32. Fit the upper tabs (press fitting).
N.B.: The upper tabs should be cut to size.
33. Install the filter(s) / fill grease.
Check for correct hood operation, referring to the section describing the hood and how to use it.
DESCRIPTION AND USE OF HOOD

1. Control panel.

2. Grease filters.
3. Halogen lamps.
4. Telescopic flue.
Control panel
a. Light switch
b. Extraction and minimum extraction (exhaust) speed ON/OFF switch
c. Average speed (extraction power) selector
d. Maximum speed (extraction power) switch
GB14