Publicidad
Idiomas disponibles
Idiomas disponibles
Models: 2210 • 2210CA
IGNITIoN INsTRUCTIoNs
1. CHECK VALVES
ensure gas is off at the supply shut off valve before checking
appliance valves�
Turn all knobs to the ❶ ❶ oFF position�
STEP 01
Push in knob and release� Knob should spring back�
STEP 02
If knobs do NoT
If knobs
do NoT spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
Rotate knob to loW then turn back to oFF� Knob should
STEP 03
turn smoothly�
3. ALwAYS CHECK BURNER FLAME BEFORE USE.
light burners and rotate knobs from HIGH to loW�
STEP 01
look below the cooking surface to view burners� When knob
STEP 02
is at HIGH, flames should be larger than when knob is at loW�
HEALTHY FLAME PATTERN
❶ ❶
❷ ❷
❸ ❸
❶ ❶
Flickers of yellow color.
Flickers of yellow color.
❷ ❷
dark blue color.
dark blue color.
❸ ❸
Vibrant blue.
Vibrant blue.
BLACKSTONEPRODUCTS.COM/SUPPORT
3. ALwAYS CHECK BURNER FLAME BEFORE USE.
YELLOw OR IRREGULAR
If there is a sudden drop or low
If there is a sudden drop or low
flame issue, please reference the
flame issue, please reference the
Troubleshooting chapter.
Troubleshooting chapter.
USING YOUR BLACKSTONE
2. BATTERY POwERED IGNITION
Clean the battery contacts and also those of the appliance prior to battery
Clean the battery contacts and also those of the appliance prior to battery
installation.
installation.
Insert one (1) AA
STEP 01
battery (not included) under the
ignitor button�
screw the button into place over
the positive terminal�
Turn gas oN by turning
STEP 02
the gas cylinder handwheel
counterclockwise 1 to 3 turns�
STEP 03
❷ ❷ Push and hold the ignitor button�
❸ ❸ Push and turn the control knob counter-clockwise to HIGH�
(Release the ignitor button when the burner lights�)
❹ ❹ Adjust the temperature to desired level�
❶ ❶
❸ ❸
❹ ❹
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
If ignition does not occur in 5 seconds:
1. Turn the burner control knob OFF.
2. Wait 5 minutes.
3. Repeat the lighting procedure.
If burner does not ignite, please reference the Troubleshooting chapter.
If burner does not ignite, please reference the Troubleshooting chapter.
| OWNER'S MANUAL
1 to 3 turns
1 to 3 turns
❷ ❷
WARNING
WARNING
13
Publicidad
