Publicidad
Idiomas disponibles
Idiomas disponibles
Trouble or fault
LEDs of the battery show
nothing
The metal construction
screwdriver doesn't start.
The control switch can't be
pressed, i.e. the switch is
locked.
The battery is not heard to
engage.
Speed of rotation drops con-
siderably.
The metal construction
screwdriver or battery gets
very hot.
The screw is pressed too
tightly against the surface.
The screw is not pressed
tightly enough against the
surface.
The screwdriver runs but the
screw can't be driven.
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
English
Possible cause
Battery defective
The battery is not fully inserted.
Battery is discharged.
Electrical fault.
The forward / reverse switch is in
the middle position.
The retaining lugs on the battery
are dirty.
Battery is discharged.
Electrical fault.
The depth gauge is set incorrectly.
The depth gauge is set incorrectly.
The wrong direction of rotation is
set.
Action to be taken
▶ Contact Hilti Service.
▶ Push the battery in until it
engages with an audible click.
▶ Charge the battery.
▶ Switch the metal construction
screwdriver off immediately,
remove the battery, keep it
under observation, allow it to
cool down and contact Hilti
Service.
▶ Push the forward / reverse
switch to the left or right.
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.
▶ Charge the battery.
▶ Switch the metal construction
screwdriver off immediately,
remove the battery, keep it
under observation, allow it to
cool down and contact Hilti
Service.
▶ Turn the depth gauge to the
right.
▶ Turn the depth gauge to the left.
▶ Set the forward/reverse switch
to the desired direction of
rotation.
2383935
*2383935*
Publicidad
