Sharp AN-65AG2 Manual De Manejo página 14

Attaching the Based Brackets to the Wall
1
Assembling based brackets A and B
Assemble based brackets A and B as shown below, and use the 6 included screws (C) (M6,
10 mm) to fasten them together.
Based bracket B
2
Determining a mounting location for the based brackets
Use the plumb bob (or washer on a string) prepared earlier to check that the based brackets
are positioned vertically. Confi rm vertical orientation using the vertical reference line on based
bracket B, and use a pencil to mark the position of the two screw holes.
3
Temporarily attaching the screws
Remove the based brackets from the wall, and temporarily attach off-the-shelf screws (M6,
2 screws) in the screw hole locations marked on the wall. When doing so, ensure that the
heads of the screws are at least 4 mm away from the wall to allow enough space for the
based brackets to be attached. Hang the based brackets over the screws, and tighten the
screws fi rmly after confi rming that based brackets are not leaning to either side.
Use off-the-shelf screws (M6, 18 screws) to attach the remaining screw holes to the wall.
E-4
Adhesive tape
-shaped screw holes
Mark the wall using a pencil.
The edge of based bracket B is used as a reference line for
determining horizontal and vertical orientation.
The letters and lines indicate the position of the center line
of the screen for the LCD color TVs. Use them as guidelines
for installation height.
A: LC-65XS1/LC-65XS1U/LC-65XS1E/ LC-65XS1RU/
LC-65XS1X/LC-65XS1M/LCD-65XS1A
4 mm or more
Wall
After checking vertical orientation
with the plumb bob (or washer on
a string) used in the previous step,
attach the circled screw holes
using off-the-shelf screws (x 20).
Based bracket A