Craftsman 113.177846 Manual Del Propietário página 9

Wet/Dry Vac Assembly
1. Line up front (label and switch side) of
power assembly with drain cap and vac
port located on the front of the drum.
Note: Power assembly must be aligned
with drum for proper attachment.
2. Place power assembly on top of drum.
3. Be sure power assembly completely
covers the top of the drum so leakage
does not occur.
4. Upon releasing flexible latches, the
power assembly will attach to the drum.
5. To remove the power assembly, lift up
on the flexible latches and remove from
drum.
Flexible
Latch _ /
Vacuum / _ ........
Port
Power
Drain
Cord Wrap
The wet/dry vac has a convenient cord
wrap area designed on the rear of the
vac. Simply, wrap the power cord around
the lid handle and cord wrap, then snap
the connector on the plug to a wrap of
the cord. The cord is now wrapped for
storage.
'- - ........... '" • ........ I
I
Insert Hose
Insert the hose locking end of the "Pos-I-
Lock" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Press
;e and
Pull
Lid Handle
On-Off
Switch
Vaccum
Release
Swivel
End
Dust
Drum
Drain
Utility Nozzle