BGS technic 7711 Manual De Instrucciones página 4

INSTRUCTIONS
PULL
Study the diagram on right side.
Select the threaded adaptor stud of the correct
size and tighten it into the crankshaft as
shown along with the puller shaft and the
flanged nut mounted on the puller shaft in the
position shown.
Then mount the puller plate onto the puller
shaft with the thrust bearing facing toward the
crankshaft.
Insert two or three bolts as needed in the
crankshaft hub or balancer.
Remove the balancer by turning the flanged
nut. To prevent the puller shaft from turning,
use a wrench to hold the spindle hex.
INSTALL
Study the diagram on the right side.
Select the threaded adapter stud of the correct
size, and tighten it into the crankshaft as
shown, along with the puller shaft and the
flanged nut mounted on the puller shaft in the
position shown.
Then mount the puller plate onto the puller
shaft with the thrust bearing facing away from
the crankshaft.
Install the balancer by turning the flanged nut.
To prevent the puller shaft from turning, use a
wrench to hold the spindle hex.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Flanged Nut
Crankshaft Hub
Puller Shaft
Flanged Nut
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Puller Shaft
Bearing
Threaded Adaptor
Crankshaft Hub
Bearing
Threaded Adaptor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed