Publicidad
Idiomas disponibles
Idiomas disponibles
4. Installnew drive belt into idler arm
assembly,then aroundthe drive pulley.
Be sure belt is inside of belt keepers.
5. Reattachidler arm assemblywith hex
nut previouslyremoved.
6. Turn lawn moweron its side. Make
sure air filter and carburetorare up.
7. Reattachdebris shield to housingwith
tab of debris shield in housing hole.
8. Positionblade on the blade adapter
aligningthe two (2) holes in the blade
with the raised lugs on the adapter.
9. Be sure the trailing edge of blade (op-
posite sharp edge) is up towardthe
engineas shown.
10.Installthe blade bolt with the lock
washer and hardenedwasher into
blade adapter and crankshaft.
11.Use blockof wood betweenblade and
lawn mowerhousingand tightenthe
blade bolt, turning clockwise.
• The recommendedtighteningtorque is
35-40 ft. Ibs.
IMPORTANT: Blade bolt is heat treated.
If bolt needs replacing,replaceonly with
approvedbolt shown in the Repair Parts
sectionof this manual.
12.Returnmowerto upright position.
13.Reattachdrivecable spring to the idler
arm assembly,then reattachdrive
cable to anchor.
14.Reattachdrivecover with screws previ-
ously removed.
15.Connectspark plug wire to spark plug.
TO ADJUST
HANDLE
The handle on your lawn mower has three
(3) height positions - adjust to the height
that suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of the
three height adjustment holes.
SQL
bracket
pin
High
Medium
\
\\
ENGINE
ENGINE
SPEED
Your engine speed has been factory set. Do
not attempt to increase engine speed or it
may result in personal injury. If you believe
that engine is running too fast or too slow,
take you r mower to a Sears or other qualified
service center for repair and adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed
main jet for mixture control.
If your engine
does not operate properly due to suspected
carburetor problems, take your lawn mower
to a Sears or other qualified service center
for repair and/or adjustment.
IMPORTANT:
Never tamper with the engine
governor, which is factory set for proper en-
gine speed. Overspeeding the engine above
the factory high speed setting can be danger-
ous. If you think the engine-governed
high
speed needs adjusting, contact a Sears or
other qualified
service center, which has
proper equipment and experience to make
any necessary adjustments.
16
Publicidad
