Publicidad
Idiomas disponibles
Idiomas disponibles
General Safety
The Omnilux Clear Device is an electrical device, which under certain
circumstances could present an electrical shock hazard to the user. Please
read this User Guide thoroughly and follow directions stated in the manual
to assure maximum safety during operation.
Omnilux Clear may only be charged with the power supply that is supplied
with the device. Use of other power supplies may not be safe and could lead
to electric shock.
Precautions
DO NOT pick or rub acne pustules that have scabbed or blocked. Picking
•
acne pustules may lead to acne scarring or worsening.
•
The Omnilux Clear straps contain a mixture of polyester, nylon, and lycra.
If you are allergic to any of these materials, you may not be able to use the
head strap provided.
The Facemask is made from Medical Grade Silicone, if you have an Allergy
•
to Silicone, you will not be able to use the Omnilux Clear device.
The Omnilux Clear Device cannot be used in charging mode.
•
•
Before each use, with the device switched off, clean the face mask. All
surfaces of the Omnilux Clear device may be cleaned by following the
cleaning instructions in Section 8.1.
DO NOT use any other cleaning products other than those stated in the
•
cleaning instructions. Use of other cleansing products may damage the
Omnilux Clear
•
Store the Omnilux Clear at room temperature in dry conditions, away from
direct sunlight.
5.0. Side Effects and Clinical Benefits
5.1. Potential Side Effects
Immediately after treatment skin may appear red. Skin should return to
•
normal within 1-2 hours.
•
Some users have reported pigmentation, skin flaking or peeling,
associated pruritis and dryness. This is transient and Clears within a few
days.
Temporary headaches immediately following the light treatment.
•
Headaches can be treated with an appropriate over the counter analgesic
and rehydration.
If you experience a side effect that is greater than that described above
or a serious side effect not listed, STOP using the device and seek advice
from a healthcare provider and report such an incident firstly to the
manufacturer Globalmed Technologies, info@omniluxled.com, who will
contact the Competent Authorities if deemed applicable. Country specific
contact numbers for Globalmed Technologies can be found
at www.omniluxled.com
8
5.2. Clinical Benefit
People who have undergone a course of 4 weekly treatments for 6 weeks
using the Omnilux Clear report a reduction of mild to moderate
acne vulgaris.
6.0. First Time Setup
6.1. Unpacking and Charging your Omnilux Clear
The Omnilux Clear device uses a controller which contains a lithium-ion
•
polymer battery. Omnilux Clear cannot be used in charging mode.
•
The Lifetime of the lithium battery can be maximised by allowing it to fully
charge and then fully discharge during regular use.
•
Unpack the Omnilux Clear and check off the parts described in Section 3.
Visually inspect the parts and connections. Return the device to your
•
supplier if you think the device or connecting parts or components are
damaged, missing, or have been previously used.
Before use, fully charge the battery.
•
•
To charge the Omnilux Clear battery insert the USB-C cable into the
controller. Insert the power supply into a suitable electrical outlet and
press the ON/OFF button on the controller.
•
The 3 LEDs in the controller will start to flash to indicate charging. The
Omnilux Clear battery is fully charged when the three indicator LEDs on
the controller stay illuminated.
6.2. Connecting the Omnilux Clear to the Controller
Ensure the controller is no longer charging by unplugging the controller
•
from the power supply.
•
Connect the Omnilux Clear mask by inserting the USB A connector of the
mask into the USB port of the controller.
6.3. Sensitization test
Before carrying out your first treatment you must carry out a
sensitization test. Follow the step-by-step guide below.
1. Connect the Omnilux Clear mask to the controller (see section 6.2)
2. Cleanse your inner arm to remove any skincare such as sunscreens.
3. Place the Omnilux Clear over your inner arm.
4. Press the ON/OFF button on the controller until lights are illuminated and
allow the device to run for its full 10 minute treatment program.
5. At any time if your skin feels HOT or uncomfortable, immediately turn OFF
your device and remove from skin.
6. After the treatment wait at least 6 hours. If your skin on your inner arm is
red or itchy then the Omnilux Clear is unsuitable for you. Return the device
to the retailer.
9
Publicidad
