Descargar Imprimir esta página

Craftsman 917.376462 Manual Del Propietário página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

_ILCAUTION:
Disconnect
spark
plug wire
from spark
plug
and place
wire where
it
cannot
come
in contact
with plug.
• Clean
the underside
of your
lawn
mower
by scraping
to remove
build-up
of grass
and trash.
• Clean
engine
often to keep trash from
accumulating.
A clogged
engine
runs
hotter
and shortens
engine
life.
• Keep finished
surfaces
and wheels
free
of all gasoline,
oil, etc.
• We do not recommend
using
a garden
hose to clean
lawn
mower
unless
the
electrical
system,
muffler,
air filter and
carburetor
are covered
to keep
water
out.
Water
in engine
can result
in short-
ened engine
life.
CLEAN
UNDER
DRIVE
COVER
Clean
under
drive
cover
at least
twice
a
season.
Scrape
underside
of cover with putty
knife or similar
tool to remove
any build-up
oftrash
or grass on underside
of drive cover.
WATER
WASHOUT
FEATURE
Your lawn mower
is equipped
with a fitting
that allows
quick
and easy cleaning
of
the underside
of the housing.
To use this
feature,
proceed
as follows:
1.
Move lawn
mower
to an area of cut
grass
or another
hard surface.
NOTE:
Water,
grass and other
debris
will
drain from
beneath
the mower
housing
during
the washout
process.
2.
Remove
grass catcher
and discharge
chute
assembly
from
lawn mower.
3.
Close
mulcher
door
(if equipped).
4.
Connect
a garden
hose to the fitting
where
shown.
IMPORTANT:
Be sure the garden
hose
is
not routed
under
the lawn mower
housing
or entangled
in the wheels.
5.
Turn on water supply
and check
for
leaks at the fitting.
If no leaks are present,
start engine
(as
described
in the Operation
section
of
this manual)
and let engine
run until the
underside
of the lawn mower
is clean.
WARNING:
Do not engage
the drive
system
during
the washout
process.
6.
Shut off the engine.
7.
Shut off water supply
and remove
hose from fitting.
CAUTION:
Do not remove
hose from
fitting
while
engine
is running.
Water
in
engine
can result
in shortened
engine
life.
8.
Start engine
(as described
in the Op-
eration
section
of this manual)
and let
engine
run for a full minute
to remove
excess
water from mower.
Hose
Fitting
15

Publicidad

loading