Publicidad
Height Display
Height Adjustment Key
Lighting effect on-off switch
ATTENTION:
Before TV mounting, RESET must be made in non-loaded condition. Please connect
the power(100-240V) and unlock touch control panel. Press and hold
display shows "1200". It indicates the unit is functioning properly. Please refer to
Reset Procedure below for specific operation.
Press and hold
Reset Procedure
its minimum height when display shows "1200". Now the reset is completed.
Save up to three commonly used heights and recall them quickly.
Press
Press
Memory Setting
Press
To restart your memory height, press and hold
The stand will move to the height you preset automatically.
ON: press and hold
Lighting Effect On-
Off Switch Setting
OFF: press and hold
TO LOCK: press and hold
Child Lock Setting
TO UNLOCK: press and hold
Press and hold
To Raise
adjustment is done.
Press and hold
To Lower
adjustment is done.
5. Touch control panel manual
Touch Control Panel
Reset Key
button until "----" flashes, reset procedure is started.The stand reaches
/
button to move the stand to the required height.
button,
lights, and then "S----" flashes.
,
or
button to assign the current height to a number, memory setting is done.
until button lights in red and lighting effect is switched on.
until button lights off and lighting effect is switched off.
until button lights in red, both control panel and remote control cannot be used.
until
button, the stand will raise at a steady speed. Release pressing, height
button, the stand will lower at steady speed. Release pressing, height
Memor y
Setting
Child Lock
,
or
appears, both control panel and remote control works again.
16/32
button until
button for two seconds accordingly.
Publicidad
