Always stay focused when working. Reduce distortion sources in your working
•
environment. The operation of the machine when being tired, as well as under the influence
of alcohol, drugs or concentration influencing medicaments is forbidden.
Work in a well ventilated area!
•
The machine must be operated only by trained persons (knowledge and understanding of
•
this manual), which have no limitations of motor skills compared with conventional
workers.
Do not allow other people, particularly children, to touch the machine or the cable.
•
Keep them away from your work area.
•
Make your workshop childproof.
•
Make sure there is nobody present in the dangerous area. The minimum safety distance is
•
2m
Use personal safety equipment: dust mask when working with the machine and note the
•
operation manual of the connected manual.
Never leave the machine running unattended! Before leaving the working area switch the
•
machine off and wait until the machine stops.
Always disconnect the machine prior to any actions performed at the machine.
•
Avoid unintentional starting
•
Do not use the machine with damaged switch
•
The plug of an electrical tool must strictly correspond to the socket. Do not use any
•
adapters together with earthed electric tools
Each time you work with an electrically operated machine, caution is advised! There is a
•
risk of electric shock, fire, cutting injury;
Protect the machine from dampness (causing a short circuit)
•
Use power tools and machines never in the vicinity of flammable liquids and gases (danger
•
of explosion)
Check the cable regularly for damage
•
When working with the machine outdoors, use extension cables suitable for outdoor use
•
Do not use the cable to carry the machine
•
Protect the cable from heat, oil and sharp edges
•
Avoid body contact with earthed
•
FIRE HAZARD:
•
Especially the aspiration of lightly flammable materials like gases, liquids, metal dust or
chippings, solvents, hot ashes, cigarette waste ... is strictly forbidden!
Do not insert any objections into the dust collector hood and keep hand away from the dust
•
collector hood when machine is connected to power supply.
Regularly check the dust collector hood for debris and clean it if necessary.
•
Do not dismount the protective fence in the dust collector hood. It is a security component
•
and must be left in place.
A first aid kit in accordance with ISO 3864 should always be readily available for
a possible accident. Initiate the violation in accordance with the necessary first
aid measures. When requesting support, provide the following details:
1. Place of accident
3. Number of injured people
11.3 Remaining risk factors
It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Despite of correct and proper use and maintenance there remain some residual risk factors:
HOLZMANN MASCHINEN GmbH
www.holzmann-maschinen.at
NOTE
Emergency procedure
2. Type of accident
4. Type of injuries
W A R N I N G
SAFETY
19
ABS 2200FLEX