HOLZMANN MASCHINEN ABS 2200FLEX Instrucciones De Servicio página 23

14.1 Maintenance plan
• Clean regularly the filter bag to ensure its filter capacity.
• You should check the dust collector hood regularly for deposits that cumulate especially on the
protective fence and clean if necessary. Failure to do so will result in lower suction capacity
and motor overload.
14.1.1 Change of dust collector bag
Empty dust collector bags when they are 60-70% full.
Switch the dust collector off and let the dust settle at least for 10 minutes.
Disconnect the dust collector from the power supply.
Do not use a dust collector bag twice.
Use solely certified dust collector bags, which match with the technical specifications, especially Ø
and height, of the dust collector
14.2 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as
well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
14.3 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a replacement
unit, the latter is obliged to exchange your old.
15 TROUBLE SHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine does not start
Dust emerges from
Loud noise in the fan wheel
housing
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
• Switch defective
• Power supply is off
• Fuse is defective
• Electric contactor is defective
• Leaking or blocked connections
• Dust bag or filter bag is defective
or incorrectly installed
• Extracting of a big part
• Loosen fan wheel
www.holzmann-maschinen.at
NOTE
• Repair switch
• Repair power supply
• Change fuse
• Repair or change electric
contactor
• Check connection
• Remove blockages
• Check bag and filter
• Change defective bag/filter
• Switch of the machine,
disconnect the machine and
remove the part
• Tighten the fan wheel
NOTE
TROUBLE SHOOTING
Solution
ABS 2200FLEX
23