Melchioni Family MF 1639B Manual De Instrucciones página 13

L) Rest the front grid on the perimeter of the rear one, taking care to match the screw+nut holes on
the lower part of both grids.
M) Close the perimeter fastenings of the grids so that they join the edges of both grids.
N) Fix the screw and the nut on the lower part of the grids so that they further hold the edges
together.
5. USE
The front selector located on the control unit starts the rotation of the propeller and consequently the
ventilation, which is proportional to the number indicated by the index on the selector. With selection
"0" the ventilation stops. Select the desired speed by gently acting on the selector, which must not be
forced beyond the indicated positions.
To start the propeller oscillation function, push the oscillation control (7) down; pull the control
upwards to stop it. It is recommended to start and stop the oscillation with the ventilation off.
The motor unit can be tilted vertically to four pre-set positions, so as to direct the flow in this direction
as well: the tilt can be done manually by grabbing the motor unit and tilting it until you hear a small
click; it is advisable to use the other hand to hold the grill.
6. CARE AND MAINTENANCE
The product does not require any maintenance. For cleaning, use a damp cloth, avoiding any aggressive
or abrasive detergent. It is essential to disconnect it from the mains before cleaning. Do not use
compressed air to clean the propeller and in any case never act to facilitate its rotation except with
normal use of the appliance. Wait for it to dry completely before reconnecting the appliance to the
mains.
7. PROBLEMS AND SOLUTIONS
In the event that the appliance presents anomalous operating conditions, in addition to what is
reported in the previous chapter 2, it is advisable to consult the following table in which to find possible
simple solutions.
Problem
The fan does not start
Swing does not start
The swing does not stop
The fan is particularly noisy
If the product shows malfunctions or anomalies other than those indicated, it is highly probable that
the problem cannot be solved independently. In this case, consult qualified technical personnel.
Possible cause
The electric plug is
disconnected from the mains
The socket the fan is plugged
into is not working
Control (7) is not fully pressed
Control (7) is not fully extracted
The parts have not been fully
secured
Probable solution
Insert the plug into a standard
10A socket
Check the efficiency of the
socket by connecting another
device surely working. If
necessary, contact an
electrician
Fully press the control (7)
Pull out the command (7)
Review the assembly process by
tightening the screws and bolts
more tightly