Ducati DCW 502 Manual De Instrucciones página 31

8. STARTING THE ENGINE
1) Unscrew prime plug and prime pump with water to overflow (place pump on level surface).
2) Turn engine switch to "ON" .
3) To start with a cold engine, put the fuel lever in the "OPEN" position and the air lever in the
"CLOSE" position.
4) Move the throttle lever from the SLOW, 1/3 position to the HIGH position.
OFF
ON
6) Pull the starter lever until you feel a slight resistance, then pull hard.
NOTICE: Do not allow the starter grip to snap back against the engine. Return it
gently to prevent damage to the starter.
7) If the choke lever was moved to the CLOSED
position to start the engine, gradually move it to
the OPEN position as the engine warms up.
8) Setting engine speed. After starting the engine, move the throttle lever to the FAST position
for self-priming, and check pump output.Pump output is controlled by adjusting engine
speed, moving the throttle lever in the FAST direction will increase pump output, and moving
the throttle lever in the slow direction will decrease pump output.
9. STOPPING THE ENGINE
To stop the engine in an emergency, turn the ignition switch to the OFF position. Under normal
conditions, follow the steps below:
1) Move the throttle lever to the SLOW position.
2) Set the switch to "OFF" .
3) Set the stopcock lever to "CLOSED"
After use, remove the drain plug from the pump and drain the pump chamber. Remove the
fill cap and flush the chamber with fresh, clean water. Let the water drain out of the pump
chamber and allow the water to drain from the pump chamber; then replace the fill plug and
drain plug.
CLOSE
HIGH
OPEN
English
Owner´s manual
OPEN
OPEN
31