Bosch PR10E Instrucciones De Funcionamiento Y Seguridad página 26

5. Lightly press centering sleeve into sub-base
or templet guide to center.
6. Tighten the pan-head screws. Remove
centering sleeve.
7. The precision centering of the subbase or
templet guide is complete.
CENTERING CONE - Used when centering
the subbase itself or wide templet guides.
CENTERINGSHAFT-_
(optional accessory)
TEMPLETGUIDE U
(optional accessory)
CENTERINGCONE
(optional accessory)
CENTERINGSHAFT
(optional accessory)
SUBBASE
__J
MAXIMUM BIT/CUTTER SIZE FOR
TEMPLET GUIDES
When using a templet guide, use only router
bit with cutters that are 1/16" less than the
internal diameter of the templet guide, such as
in the table below.
Bosch Bushing
Templet Depth
Guide
USE WITH THREADED
TEMPLET GUIDES
Also available as an optional accessory is an
additional adapter, the RA1100, that allows
use of conventional threaded templet guides
with the Bosch quick-release system.
External
Diameter
A B
RA1101 3/16" 5/16"
RA1103 9/64" 5/16"
RA1105 9/64" 7/16"
RA1107 5/16" 7/16"
RA1109 7/16" 1/2"
RA1111 3/16" 5/8"
RA1113 1/2" 5/8"
RA1115 3/16" 3/4"
RA1117 31/64" 13/16"
RA1119 31/64" 1"
RA1121 7/16" 1-3/8"
Internal Max
Diameter Bit/Cutter
Diameter
B
1/4" 3/16"
17/64" 13/64"
3/8" 5/16"
3/8" 5/16"
13/32" 11/32"
17/32" 15/32"
17/32" 15/32"
21/32" 19/32"
5/8" 9/16"
25/32" 21/32"
1- 19/64" 1-15/64"
-26-