Descargar Imprimir esta página

Costway NP10259DE Manual Del Usuario página 8

Spa hinchable

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
4.3 Drainage of SPA pool
(1)
a: Use the plug in the repair bag to block the outlet at the bottom of the
pool. see fig A;
b: Open the cap of the outlet pipe under the outer wall of the pool, see fig B;
c: Connect a white drain pipe in the pool set for drainage, see fig C;
A)
A)
B)
(2) Pour out the water from the SPA pump first.see fig 1. Then connect the
outlet of bubble and water outlet.see fig 2. Press bubble key and make it
work for 2-3 minutes to blow out the remaining water inside the SPA pool.
1
4.4 SPA Pool Filter Cartridge Replacement
Warning: The circuit breaker must be cut off before beginning spa
maintenance to avoid severe risk of injury or death.
NOTE: Dirty filter cartridge not only affects the cleaning of water in the pool,
but also affects the heating effect of SPA pump. Therefore, it is recommended
to clean the filter cartridge regularly according to the water treatment
chapter.
(1) First pull off the plug
(2) Cover the water inlet and outlet with the cover included;
(3) Rotate counterclockwise to remove the filter cartridge; (Figure 1)
14
C)
2
(4) You can rinse the filter cartridge directly with water (Figure 2), but if the
filter cartridge is still dirty or has changed color after rinsing, it is
recommended that you replace the filter cartridge.
(5) Install the washed filter cartridge into the SPA pool wall.
(1)
5. SPA Maintenance
5.1 Water Requirements for SPA
We require the PH value of the water used in the pool to be between 6.5 and
8.5. If the PH value is too low or too high, it will affect the service life of the
pool and pump of SPA and bring harm to human health. Therefore, we
suggest that customers can use PH test paper to test the water quality before
using it.
5.2 SPA Water Treatment
Note: Ensuring the cleanliness of the water in the pool is very important for
your health. We suggest you do the following things:
(1) Regularly start the filtration system of SPA pump to clean the water in
SPA pool;
(2) The filter cartridge of SPA pump must be cleaned every 3 days, and the
filter cartridge must be replaced on average once a week according to the
frequency of use.
(3) Replace the water in the pool every 3 days and then clean the pool clean
with a clean cloth.
(4) SPA can be treated with suitable chemicals for SPA, and the water in SPA
pool can be disinfected with appropriate disinfectant every day. The
disinfectant will kill bacteria and viruses in the water. Please consult
qualified technician before use.
(2)
15

Publicidad

loading