Beta 1851VK Instrucciones página 6

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING HOT GLUE GUN
Failure to observe trhe following warnings may result in physical injury and/or disease
ALWAYS WEAR SAFETY SHOES.
ALWAYS WEAR HEAT PROTECTION GLOVES.
ALWAYS WEAR EYE PROTECTION.
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey if the values exceed the limits under current regulations.
TECHNICAL DATA
Input 220V-240V, 50Hz, 80W
GUN USE
- Connect the hot glue gun to an AC socket that satisifies the requirements in "Technical Data".
- Leave the gun to warm up for approximately 3-5 minutes.
- Insert a glue stick into the back hole of the tool.
- Squeeze the trigger slowly, until the melted glue begins to flow from the nozzle.
- Apply the glue to the desired surface..
- Release the trigger, to stop the glue flow.
- Disconnect the gun from the mains power supply after use.
- If some glue is left in the gun while cooling down, it can be melted again, by heating the tool up.
MAINTENANCE
Repair and calibration jobs must be carried out by trained personnel only. For such jobs, you can contact Beta Utensili S.P.A.'s
repair centre
DISPOSAL
The crossed-out wheelie bin symbol on the equipment or packaging means that the product should be collected separately from
other types of urban waste at the end of its useful life.
Any user who is going to dispose of this tool can:
- Deliver it to an appropriate collection facility for electronic or electrotechnical equipment
- Return it to the dealer upon purchase of a new equivalent item of equipment
- in case of a product for professional use only, contact the manufacturer which will arrange for the product to be properly
disposed of
Proper disposal of this product allows the raw materials contained in it to be reused and prevents damage to the environment or
human health. Illegal disposal of this product is a violation of the provision concerning the disposal of hazardous waste abd will
give way to the application of such fine sas privided for under current regulations.
6
EN I