Charging The Electric Corkscrew; Using The Electric Corkscrew - Ambiano MD19190 Manual Del Usuario

Charging the electric corkscrew

1. Connect the charging cable of the power adapter
connector 10
2. Connect the power adapter to a power outlet.
3. Place the electric corkscrew
The blue LED light at the corkscrew spiral will light up when the corkscrew is
correctly positioned on the charging base. Charging will start automatically.
It will take approximately 2.5 hours to fully recharge the electric
corkscrew. With a full charge, approximately 60 bottles can be
opened.

Using the electric corkscrew

1. Use the foil cutter
the cork. To do so, place the foil cutter around the neck of the bottle and
then turn while pressing it gently (see Fig. C).
2. Place the electric corkscrew
that it remains as upright as possible at all times.
If you hold the corkscrew at an angle to the bottle, the cork will not be
removed properly.
3. Hold the corkscrew firmly and press the cork removal button
(see Fig. D).
The corkscrew spiral will turn in a clockwise direction and enter the cork,
then gradually remove the cork from the bottle.
When the corkscrew stops, the cork has been fully removed from the bottle.
4. Lift the corkscrew away from the bottle.
5. Press the cork ejection button
(see Fig. E).
The corkscrew spiral will turn in a counterclockwise direction and release
the cork.
6. Return the electric corkscrew to the charging base
on the charging base
1
to remove any foil from the bottle before removing
7
1
(see Fig. B).
6
on the charging base.
on the top of the wine bottle, making sure
2 to remove the cork from the corkscrew
Charging the electric corkscrew
to the charging
9
3
after use.
6
13