UFESA LC5000 Manual De Instrucciones página 8

Juice extractor assembly
1
Insert the bowl on the motor so that the groove fits
into the slit of the motor housing.
2
Insert the sieve on the driver, press until stop and
check if it is correctly inserted and it turns easily.
3
Insert the lid on the bowl.
4
Lift both clamps and insert the fastenings in the
openings of the lid.
5
Press the clamps to the housing (you will hear
a characteristic click).
6
Place an appropriate utensil under the groove
discharge.
Start up and operating
the juice extractor
● Check if the switch is in the "0" position.
● Unwind a sufficient length of the cord. The
remaining cord can be stored in the housing. Put the
remaining cord in the housing through the opening
situated at the side of the juicer.
1
Plug in the appliance and switch it on.
2
Place the product to be processed into the feeding
tube and gently press with the pusher.
After operation
(after extracting the juice)
1
Switch off the appliance.
2
Unplug the appliance.
● Dismantle the parts – as in the case of the initial wash.
Maintenance
● After you have finished clean the juice extractor
thoroughly to avoid the residue drying out.
● The motor base housing should be cleaned with
a wet cloth and a small addition of a washing-up liquid.
● The other components (juice bowl, cover and food
pusher) should be cleaned after finishing the work in
a lukewarm water with an addition of a washing-up
liquid. Rinse them and dry. These component may be
also cleaned in a dishwasher at max. 60°C (except the
strainer).
● Use a dish brush to remove dirt from crevices or
corners.
C
● Over time plastic parts may become discoloured.
This is not a product defect.
● After washing, dry all elements thoroughly.
● Assemble the unit as described in section
What to do when:
The juice extractor does not work:
● Return the juice extractor to a service facility.
The juice is extracted in a poor manner, the juice
extractor is subject to vibrations:
● Switch the appliance off, clean the strainer from any
residue, empty the waste receptacle,
● Replace the strainer in case of mechanical damage.
D
How to extract juice from fruits
and vegetables:
● Remove stones from fruits as they may damage the
juice extractor.
● Carefully wash the fruits and vegetables to be
processed.
● Wash berries directly before processing, as they
quickly lose freshness.
● Extracting juice from plums, blueberries, raspberries
and soft pears is troublesome. The pulp of these fruits
blocks the openings of the sieve. You can process these
fruits by mixing them in small quantities with other fruits
E
and vegetables. In such a case the sieve has to be
cleaned more often.
● While extracting juice from grapes, insert whole
fruits into the feeding tube, without the stem.
● Cut bigger fruits and vegetables into pieces before
processing.
● Insert the fruits and vegetables into the feeding tube
after switching on the appliance.
● The nutritional value of the raw juices is similar to
the nutritional value of the fruits and vegetables, except
that the juice does not contain fiber which is removed
during juice processing.
Juice obtained from some fruits and
vegetables has a tendency to concentrate.
This is due to the characteristics of the
used products and it is not influenced by the
juice extractor. The obtained juice might not be
clear, but this kind of juice has the most
nutritional value.
C
.