When The Oven Is Working - Pando PHM9500 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN

When the oven is working...

Interrupting a cooking cycle
You can stop the cooking process at any time by
pressing the Stop key once or by opening the
oven door.
In both cases:
 Microwave emission is stopped immediately.
 The grill is de-activated but is still very hot.
Danger of burning!
 The timer stops and the display shows the
remaining amount of operating time.
If you wish, at this time you can:
1. Turn or stir the food to ensure it will be
evenly cooked.
2. Change the process parameters.
3. Cancel the process by pressing the Stop
key.
To restart the process, close the door and press
the Start key
Altering parameters
The operating parameters (time, weight, power,
etc.) can be altered when the oven is operating or
when the cooking process has been interrupted
by proceeding as follows:
1. To modify the time, turn the rotating knob
(8). The new time defined is immediately
valid.
2. To modify the power, (only when the cooking
process is interrupted) press the OK key (4).
The respective indicator starts to flash. Alter
the parameter by turning the rotating knob
(8) and confirm by pressing the OK key (4).
3. To modify the function, (only when the
cooking process is interrupted) turn the
Function selection knob (1) and change
the parameter.
4. To modify the weight, (only for the function
"Defrosting by weight" and when its process
cooking is interrupted) press the OK key (4)
and modify the parameter with the rotating
knob (8).
15
Cancelling a cooking cycle
If you wish to cancel the cooking process, press
the Stop key twice.
You will then hear a beep and the time will appear
on the display.
End of a cooking cycle
At the end of the process you will hear three
beeps and the display will show the word "End".
The beeps are repeated every 30 seconds until
the door is opened or the Stop key is pressed.

Publicidad

Tabla de contenido
loading

Tabla de contenido