Ubbink Robotclean Accu XL Pro Manual De Instrucciones Y Lista De Piezas página 5

1 Robotclean Accu XL Pro Operating Manual and Parts List
Attention: The pool cleaner must always be placed in or removed from the pool in such a way that the underside of the pool cleaner faces the pool wall to avoid possible scratches on
the pool or film surface.
6. Slide the switch to the right. The blue indicator lights up and the cleaner is switched on.
The pool cleaner activates automatically as soon as it is fully immersed in the water.
The vacuum pool cleaner starts working about 15 seconds later, while the blue light flashes.
The pool cleaner automatically changes direction as soon as it touches the pool wall (or rises up and down for pools with a curved bottom) and the blue light flashes. The yellow light
flashes after the work cycle is completed and the cleaner moves automatically towards the pool wall. After reaching the pool wall, the light on the cleaner is constantly illuminated
yellow.
7. Lift the cleaner out of the water using the hook and push the switch on the cleaner to the left. The red indicator flashes once and the cleaner is switched off. Hold the cleaner above
the water for 10-15 seconds to allow the water to drain from the device.
Tips and advice
- When commissioning the pool after winter storage, the floor must be cleaned for the first time with a landing net or vacuum cleaner before the robot is used.
- The pool cleaner and the filter insert should be cleaned after each use.
- The pH-value of the pool water should be between 7.0 and 7.4.
- The water temperature should be between 10°C and 35°C.
- Do not leave the pool cleaner in the pool constantly.
- Do not operate the pool cleaner during a chlorine shock treatment.
Troubleshooting
Fault
The pool cleaner is not working and the indicator
lamp does not flash
The adapter does not work
The pool cleaner is not working and the yellow
indicator lamp flashes slowly.
The pool cleaner is not working and the red
indicator lamp flashes slowly
The pool cleaner cannot clean all areas
MAINTENANCE
Use conventional care products for cleaning. Do not use solvent-containing or abrasive cleaning agents, hard sponges, brushes, etc.
Cleaning the filter unit

CLEAN THE FILTER UNIT AFTER EACH CLEANING CYCLE
- Stellen Sie den Poolreiniger auf eine ebene, saubere Oberfläche und entfernen Sie die obere Abdeckung, indem Sie die Tasten auf beiden Seiten drücken
Figure 1
- Press the opening button on the front of the cleaner (see Figure 1)
- The top cover opens automatically (see Figure 2).
- Remove both filter baskets (see Figure 3).
- Clean both filter baskets (see Figure 4).
- Replace the cleaned filter baskets. Pay attention to the correct installation position.
- Close the top cover.
Manual RobotClean Accu XL 2023_1.indd 3 Manual RobotClean Accu XL 2023_1.indd 3
Cause
Function to protect the battery
The adapter or rechargeable battery is defective
The adapter is defective
Low remaining battery capacity
Pool cleaner malfunction
Your pool's water circuit is switched on
Figure 2 Figure 3
Solution
Charge up the battery
Contact your salesperson
Contact your salesperson
Charge up the battery
Charge up the battery
Contact your salesperson
Switch the filter pump off
Figure 4
05.12.23 12:19 05.12.23 12:19