Sinbo SEL 6020 Instrucción Del Uso página 8

4. Started from the fine hair on arms,wait until the skin is adjusted before removing the thicker hair.
the unwanted hair is reeled to remover and thus will cause a minor discomfort theissitations will after
use for 2 or 3 times.
5. After the remove hair,apple your favorite cooling gel or lotion at removed hair area(Ex.:Lotion with
aloe ingredient, please use allcohol-free toning lotion)
6. During use,if you want to stop the main uint immediately, puch down the switch to stop.
7. It is normal if the cotton thread is broken while you are using it, please replace the cotton thread,and
you can use it again.
HOW TO FIT THE COTTON THREAD
Step 1: Tack some cotton thread (length
less 36cm) from the attachment. First Pass
the thread through the middle hold, keep
the same length two side.
Step 3: Entwine the left thread in the
bottom of the left bolt and fasten the bolt.
FREQUENTLY ASKED QUESTION
Question: Can't remover the hair completely, Gread pain caused when pulling the hair?
Answer: Are you moving at the right direction, move against the direction of the growing hair? Has the
cotton thread been placed correctly to your skin? Have you dried your skin and hair completely before
use? Have you applied the loose power? Have you applied lotion?
Question: lrrtations occur?
Answer: Your skin is still adjusting to the new techniques, the irrtations will stop use for 2 or 3 times.
Question: How long need replace the cotton stread?
Answer: Replace every single time after use.
Question: The cotton thread can't roll smoothly?
Answer: Have you placed the thread corretly? Have you fastened the bolt that keeps the thread in
position?
INSTRUCTION FOR USE
- 7 -
Step 2: Pass the two side threads through
the top holes of steel wire.
Step 4: Tighten the right thread then
entwine in the bottom of the right knob,
fasten the bolt.