Genius Dental Hydro Fusion Instrucciones De Uso página 20

GB
1. To connect, insert the water hose firmly into the water inlet on the back of the main unit.
1. To disconnect, pull out the water hose, and immediately insert the water hose into the small hole on the bottom of
the charging station to prevent water leakage from the tank. (See Fig. B)
Charging the battery
Make sure that the main unit is switched off
Option 1: Charging in the charging station with water hose
1. Insert the mains plug into the charging socket on the back of the charging station. (See fig. D).
2. Plug the mains adaptor into a functioning socket.
3. Dry the contact surface of the main unit and the base.
4. Place the unit in the charging station so that charging contact is established.
Option 2: Direct charging of the main unit
1. Plug the Type-C USB cable into the charging socket on the underside of the main unit. (See fig. E)
2. Plug the mains adaptor into a functioning socket.
Battery indicator
TIP!
When using the appliance for the first time or if it has not been used for more than 6 months, the battery
indicator may not light up at the beginning of the charging process. In this case, please charge the appliance
for at least 6 hours.
When the battery is low, the battery indicator flashes red.
„
During charging, the battery indicator lights up red.
„
When the battery is fully charged, the battery indicator lights up green.
„
Filling the water tank
1. Remove the storage box.
2. Fill the water tank with cold or lukewarm water.
3. Put the storage box back on the water tank.
Mouthwash
1. Hold the appliance so that the handle and nozzle attachment point into the water basin.
2. Press the floss button to get the water flowing.
3. After water comes out of the nozzle, deactivate the water flow by pressing the floss button again.
4. Once you get used to using the function, you can continue using it.
Use
TIP!
In cleaning mode, the hose can be disconnected from the main unit. There is also no need for water in the
water tank.
20
Instruction manual