General Instructions - heatwell AVANT TOUCH 800 W Manual De Instrucciones

2.6. FP MODE
In this mode the device works following instructions of an external unit.
How to select FP mode?
A.- Press OK
B.- Press key , select FP; press OK to validate.
C.- The display will show the set temperature together with a red dot that indicates the unit is working in FP mode.
If FP mode is selected the heater cannot be turned off. To turn off the device, enter mode (MODE/OK), select MAN using
 and press OK. Now you can turn off the device using
2.7. COPY FUNCTION
This function enables you to copy existing time programmes. To copy the setting of one day into another, do as follows:
A.- Press OK for a few seconds.
B.- Press , select COPY DAY and press OK to validate.
C.- Press , select the day to set and press OK to validate.
D.- Press , select the day to copy; press OK to validate.
If we want to go on copying into other days, turn to B. If not, press
2.8. PROTECTED FUCTION
This function enables to block the controls. To set this function, do as follows:
A.- Press OK for a few seconds.
B.- Press , select PROTEC and press OK to validate.
C.- Press , select ON, and press OK to validate.
To unlock the device, wait until dashes disappear from the screen; press key
2.8. SOUND FUNCTION
SOUND function enables to activate and deactivate the beep emitted on touching the buttons. To activate or
deactivate do as following:
o Press button OK for a few seconds
o Press , select SOUND, and press OK to confirm.
o Press , select ON or OFF to activate or deactivate the beep, and press Ok to confirm.

3. GENERAL INSTRUCTIONS

 If we enter a submenu, and stop using the device for a few seconds, it automatically returns to the main menu.
 If we are in the main menu, and the device is not being manipulated; it will turn to stand-by mode and the display
will only show a dot. Touch any button to redisplay the main menu.
 To turn on the screen again, press any key on the button panel.
 Being the device OFF, the radiator can start working. This is because it has a minimum set temperature as per
factory set, 7ºC. This mode is called ANTIFROST –it prevents room temperature going below said temperature.
The device is provided with a protection against loss of temperature caused by open window, air conditioners, or

any other circumstance that may prevent the radiator from raising the room temperature. This mode activates
when the temperature decreases 3ºC in 5 minutes. At this stage, the radiator turns off and shows OPEN on the
display; this mode stays until this decreasing tendency disappears.
On unplugging the device, it may beep; this indicates the discharge of the capacitors. This does not affect the

radiator's output.
4. MAINTENANCE
 Keep the floor clean to avoid stains on the wall.
 At the beginning of the year's heating season, the inner parts of the radiator should be vacuumed because dust can
be accumulated in the heating element while the time of the year that the radiator is been off.
 The device can be washed with a moistened cloth or with any washing conventional product.
for 5 seconds; press  to validate.