cecotec FORCECLIMA 12600 SOUNDLESS HEATING Manual De Instrucciones página 35

ENGLISH
and prevent it from mildewing.
- Turn off the appliance, unplug the power plug, and wrap the power cord around the
wrapping post. Install the water plug and the drain cap.
Remove the exhaust pipe and keep it properly.
-
- Cover the air conditioning with a plastic bag. Put the air conditioning in a dry place, keep it
out of the reach of children, and take dust control measures.
- Remove batteries of the remote control and keep them properly.
Ensure that the body is placed in a dry place and keep all machine components properly.
-
Maintenance
Any person who is involved with working on or breaking into a refrigerant circuit should hold a
current valid certificate from an industry-accredited assessment authority, which authorises
their competence to handle refrigerants safely in accordance with an industry recognised
assessment specification.
6. TROUBLESHOOTING
Problems Possible causes
The air There is no electricity.
conditioning
does not
The full-tank indicator will
work.
flash.
The room temperature is
too low or too high.
In cooling mode, the room
temperature is lower than
the set temperature; in
heating mode, the room
temperature is higher than
the set temperature.
In dehumidification mode,
the room temperature is
very low.
68 FORCECLIMA 12600 SOUNDLESS HEATING
Possible solutions
Turn it on after connecting it to a socket
with electricity.
Discharge the water inside.
It is recommended using the appliance in at
the temperature of 7-35 ºC.
Change the set temperature.
The appliance is in a room with a
temperature below 17°C.
There is direct sunlight.
The cooling
Doors or windows are
effect is not
open; there are a lot of
good.
people; or in cooling mode,
there are other sources of
heat.
The filter screen is dirty.
The air inlet or outlet is
blocked.
The device The air conditioning is not
makes a lot placed on a flat surface.
of noise.
Compressor There is frost.
does not
Protection against
work.
overheating system is
activated.
The remote There is too much distance
control does between the machine and
not work. the remote control.
The remote control is not
aligned with the direction
of the remote control
receiver.
Batteries are dead.
Displays 'E1'. The room temperature
sensor is abnormal.
The display The pipe temperature
shows "E2". sensor is abnormal.
1. Service information
1.1 Area verification
Before starting work on systems containing flammable refrigerants, safety checks are
necessary to ensure that the risk of ignition is minimised. Before repairing the cooling system,
the following precautions must be observed:
1.2. Work procedure
ENGLISH
Pull the curtain.
Close doors and windows.
Clean or replace the filter.
Clear obstructions.
Put the air conditioning on a flat and hard
place (to reduce noise).
Wait for 3 minutes until the temperature is
lowered, and then restart the appliance.
Let the remote control get close to the
air conditioning, and make sure that
the remote control directly faces to the
direction of the remote control receiver.
Replace batteries.
Contact the official Technical Support
Service of Cecotec.
Contact the official Technical Support
Service of Cecotec.
FORCECLIMA 12600 SOUNDLESS HEATING 69