Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING INSTRUCTIONS
STEP 1 - Pre charge check and electrolyte level check
• Check the battery electrolyte level (not required on sealed or maintenance free batteries). If necessary,
remove the vent caps and add distilled water so the levels are halfway between the upper and lower fill
lines.
• Check the voltage output switch on the charger and make sure it's on the correct voltage.
STEP 2 - Connecting the battery charger to your battery
• Select the plug needed (eyelets or alligator clips) and connect it to the charger.
• Connect the red lead from the charger to the positive (+) battery terminal.
• Connect the black lead from the charger to the negative (-) battery terminal.
STEP 3 - Connect the battery charger to mains power (240Vac)
• Connect the battery charger to a 240Vac mains powered socket.
• Turn on the 240Vac mains power and select the battery mode to start the charging process. Before
choosing, please read the charging mode to understand the differences between each mode.
STEP 4 - Disconnecting the battery charger from battery once the charge is finished
• Switch off and remove the AC power socket from the outlet.
• Remove the black cable and then the red cable.
• Check electrolyte levels if possible (As they may need topping up with distilled water after charging).
CHARGING PROCESS
Charging phases:
• Confirm the battery voltage and chemical properties.
• The AC power plug has been inserted into the power socket, press the mode button to switch to the
charging mode suitable for the battery voltage and chemical properties.
• The charger will start in standby mode with a green led indication. In this state, the charger does not
provide any power.
• Confirm that the positive and negative terminals of the battery and the terminal connecting wire or
clip wire are correctly connected.
• The mode led will light up the selected charging mode, and the charging led display will light up
(depending on the health of the battery), indicating that the charging process has started.
EN
11
Publicidad
