Lampa AMPEROMATIC BIKE Manual De Instrucciones página 13

PROBLEM DIAGNOSIS
Use this table when an error is displayed, a series of flashing red led lights to help determine the error.
The number of flashes indicates the corresponding fault (see list for details).
Malfunction
Error led single flash
Error led double flash
Power led triple flash
Power led red light
always on
TECHNICAL SPECIFICATIONS
Name - Amperomatic Bike
Type - Automatic 3 stages
Approvals - CE, RHOS
Input voltage range - 220V-240Vac
Input frequency - 50Hz
Max output voltage - Various
Charging current - 1A(6V/12V)
Housing material - ABS
Protection - IP60
MAINTENANCE
The charger is maintenance free. If the power cord is damaged, the charger must not be used.
The case should be cleaned occasionally. The charger should be disconnected from the power while
cleaning. Do not expose to rain and do not dispose of waste electrical and electronic equipment with
domestic rubbish.
Cause/Solution
When the DC output connection is reversed, the error red led flashes once
and goes off once.
When the AC output is short-circuited the error red led flashes twice and
goes out once.
When the charging is in the overheat protection state, the power red led
flashes three times and goes out once.
The charger is connected to an uncorrected battery or the battery is
damaged. Have the battery checked by a professional.
ENVIRONMENTAL CHARACTERISTIC
• Operating temperature: from 0 to 45°C.
• Storage temperature: from -25 to 85°C.
• Operating humidity range: from 0 to 90% RH.
• Cooling: passive / natural
EN
13