FONESTAR ASB-880U Manual De Usuario página 4

EN
CONNECTION
- Before turning on the power, make sure that the volume controls are set to minimum and the POWER
switch is turned off.
- Connect the power cord of the equipment to the power outlet.
- Connect a line level signal to the LINE IN input of the loudspeaker, coming from the output of a mixer,
CD player, etc. You can also connect a USB storage device or SD memory card; or use the FM tuner.
- Turn on the speaker with the POWER switch on the rear panel.
- Ajuste el volumen de las entradas al nivel deseado con los controles correspondientes.
- The REC OUT speaker output provides a line level for input to another amplified loudspeaker, mixer,
amplifier, recorder, etc.
- Furthermore, if you wish, a passive loudspeaker can be connected to the SPEAKER OUTPUT terminal.
- When not using the equipment, switch it off: turn the volume controls to minimum, deactivate it with the
POWER switch and disconnect the power supply from the mains.
WIRELESS CONNECTION OF 2 SPEAKERS
This speaker can be connected wirelessly to another speaker from the same series by following the steps
described below:
1.- Turn on both speakers and select wireless mode. The display will show BLUE.
2.- Long press the MODE button. This speaker will be the MASTER speaker and will play the left (L)
channel of the stereo signal. The other speaker will be the secondary speaker (SLAVE) and will play
the right channel (R) of the stereo signal.
Once connected the main speaker will show bt-L on the display, and the secondary speaker bt-R.
3.- Connect your wireless audio device to the MASTER speaker and you will hear another beep
indicating that it has been successfully connected.
4.- If you want to unlink both speakers, long press the MODE button again.
PLAYER
AMP
SB-3608
- 4 -
USB
/
SD MMC CARD
PREV PLAY NEXT
MODE
VOL- PAUSE VOL+