E
① x 8
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
1. Unpack the unit and confirm that you have all the hardware and required parts listed. Assemble the unit
on a carpeted floor or the empty carton to avoid any scratch.
2. Position the Table Top (D) upside down on a level and protective surface.
3. Remove the plastic caps from the hanger bolts of Legs (E). Attach 4 Legs (E) to the corner blocks of the
Table Top (D) by inserting the pre-attached hanger bolts through the drilled holes on corner blocks, and
fit the Flat Washer (3), Lock Washer (2) and Hex Nut (1) onto each hanger bolt. Tighten the hex nuts
with the provided open wrench.
Assembly Instructions
3
2
1
E
E
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
E
D
D
② x 8
4
Pre-attached
E
E
③ x 8