Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
A fastener can be driven unintentionally if the trigger and safety
bracket are activated at the same time. Always disconnect tool
from air supply before loading fasteners, making adjustments, or
performing any service on tool. Keep finger off trigger until ready
to drive a fastener.
LOADING INSTRUCTIONS
1. Pull pusher (A) back to latched
position at rear of magazine.
2. Loadstaplestrips(B
overmagazinetrack. Slide strips down
so that staple crowns ride on top rail,
then slide forward toward tool nose.
3. Pull pusher (A) back and press
release lever to release latch. Slide
pusher forward against staple strips
and release. DO NOT allow pusher to
snap forward against staples.
4. Tool is now loaded and ready
to be connected to an air supply
for operation.
5. Reload when indicator triangles on
magazine and pusher are aligned.
CLEARING NAIL JAMS
1. Disconnect tool from air supply
using quick-connect coupling.
2. Pull pusher back to latched
position at rear of magazine.
3. Open E-Z Clear latch and open door.
4. Remove jammed fastener.
5. Close door and secure with latch.
6. Release pusher and slide
forward against nail strips.
7. Connect air supply and check
tool for normal operation.
DANGER
10
Publicidad
