Grip Rite GRTS2650 Manual Del Operador página 13

MAINTENANCE
Your tool will last longer and perform better if periodic maintenance is
performed. Please use the information below to keep your tool operating
in top condition.
Lubrication
Disconnect tool from the air supply and remove all fasteners.
Apply 2 - 3 drops of air tool oil (provided) in the air inlet two -
three times a day. If the tool will be used outside in the winter,
use a winter grade air tool oil to help keep frost from forming
inside the tool. Do not use other types of lubricantson this tool,
as other lubricants may containchemicals harmful to o-rings
and other tool components. Drain compressor tanks and
hoses daily.
Cleaning
Disconnect tool from the air supply and remove all
fasteners.Brush tool off using a parts cleaning brush
or clean rag. Check area around trigger and workpiece
contact, and clean as necessary. Pull pusher back to
latched position, and brush out staple entry area of
tool nose. Open E-Z Clear latch and brush out debris.
Blow out confined areas around tool nose using low
pressure compressed air.
Trigger Check
Check trigger operation daily:
1. Press the workpiece contact against a safe work surface without
depressing the trigger. THE TOOL MUST NOT CYCLE.
2. Hold the tool above a safe work surface and pull the trigger without
depressing the workpiece contact. THE TOOL MUST NOT CYCLE.
3. The trigger must return to the normal position each time finger
pressure is released.
13
MAINTENANCE