ECG ZS 1420 Manual De Instrucciones página 44

Cortadora de barba
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

CHARGING
Charging
NOTICE! Property damage
Remember that the battery capacity is shorter after longer storage
periods. Therefore long charging times due to interruption between
charging and discharge cycles should be avoided. We recommend
that the battery is fully discharged before charging for the first time.
Do not charge the trimmer continuously for more than 24 hours.
Do not leave the trimmer permanently plugged into the charging
cable.
WARNING: Use for charging exclusively the charging cable
supplied with the trimmer. Make sure before charging
that the switch is in the „OFF" position.
NOTES
Connect the charging cable to the device. Connect the charging
cable to an easily accessible electrical outlet. When the cable is
plugged into the power supply, the red diode on the trimmer body
is constantly on. To extend battery life, we recommend the following
charging times:
First charging - charging time about 12 hours
Each additional charging - charging time about 8 hours
1× in six months – we recommend to extend the charging time to
about 12 hours.
Warning: The red diode is constantly on even after the device is
fully charged.
The operating time with a fully charged battery is about 35-40
minutes.
OPERATION
NOTES:
The trimmed beard must be dry.
vary according to the cutting angle.
44
The length of the cut may
First, start with the comb

Publicidad

Tabla de contenido
loading

Productos relacionados para ECG ZS 1420

Este manual también es adecuado para:

Zs 1421

Tabla de contenido