Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4.1 Now, go back and tighten all bolts. Make sure that
all the parts are tight and there are no gaps between
the parts. This will help keep the unit square.
4.2 Flip the assembled unit around at its front edges.
Unfold the Back Panel (I) and position it onto the back
edges of the assembly. Make sure that the overlaps
on the panels are even all the way around. Secure the
Back Panel (I) in place with the 15 mm Washer Head
Screws (EE).
NOTE: We recommend attaching back panel with the
screws at the corners first.
Hardware Used
M3.5 x 15mm
EE
Washer Head Screw
5. Attach the Metal Frame (K) between the Legs (J) with
four 32 mm Bolts (AA), four Lock Washers (BB) and
four Flat Washers (CC).
Hardware Used
1/4"x 32mm Bolt
AA
1/4" Lock Washer
BB
1/4" Flat Washer
CC
6. Attach the assembled base to the Bottom Panel (B)
with six 32 mm Bolts (AA), six Lock Washers (BB), six
Flat Washers (CC) and six 32 mm Screws (FF).
Hardware Used
1/4"x 32 mm Bolt
AA
1/4" Lock Washer
BB
1/4" Flat Washer
CC
M4 x 32 mm
FF
Screw
4
Adhesive tape
faces outward
x 24
5
x 4
x 4
x 4
6
x 6
x 6
x 6
x 6
B
7
K
AA
BB
CC
J
CC
FF
EE
I
J
BB
AA
FF
Publicidad
