Green Wallbox EV Cable Type 2 Manual De Instrucciones página 4

EN
Vehicle charging stations
1. Plug the cable into the socket of type 2 of the charging
station. Always perform this step first.
Note! Make sure the cable is fully extended.
2. Connect the plug to the electric vehicle.
3. Charge.
4. After charging, first, disconnect the cable from the vehicle
and then from the charging station.
5. When charging is complete, place the cable in the case.
Problem-solving
If charging does not start, check the following possible
causes:
1. Make sure the cable is fully plugged into the charging
station socket.
2. Make sure the cable is fully plugged into the vehicle
socket.
3. If the vehicle connector is a Type 2 connector
4. With a catch, check that the catch is fully inserted.
5. If none of the above works, disconnect the connectors
at both ends and check whether there are any foreign
bodies stuck in them. If the problem persists contact the
service department.
4