Publicidad
Idiomas disponibles
Idiomas disponibles
Fan OFF
Natural wind
Speed of the fan
Forward/Reverse
Fan timer
Warm light
Natural light
Cool light
Brightness control switch
Light ON/OFF
1.5V AAA batter y X2pcs (not included)
KINDLY REMINDERS:
1. lf the emitter can not control the fan, learning code matching mode is used between
emitter and receiver. Turn "ON" the supply power within 10 seconds and press the
emitter's "
" button for 5 seconds, it can load normally af ter hearing a long sound
"bee", which means learning successfully and it can works normally.
(PS: Learning mode is not accepted af ter turn "ON" the supply power for 10 seconds)
• When the emitter cannot control the receiver, please check the batter y switch touching
normally or not,correction of the positive and negative, full or empty of the power.
• When the emitter cannot control the receiver, please check is there any existence of
similar remote controlled products nearby, then check whether they works, because
remote controlled product with the same frequency will disturb each other.
• Low voltage of batter y will affect the sensitivity of the emitter and the signal reception
accordingly(the indicated light will flash out its warning when the batter y get low
voltage),must replace if the batter y is getting low voltage.
• Please take out the batter y from the emitter when leaving unused for long time.
· When installing the fan,the fan ceiling cover don't press the antenna(or other wire),
it is easy to breakdown the wire and shor t-circuited.
Dpto. Comercial / Marketing
pedidos@algsa.es
REMOTE CONTROL SETUP
20
MANUAL DE INSTRUCCIONES
INSTRUCTIONS MANUAL
Publicidad
